View Single Post
Old 05/07/2016, 06:20 AM   #4
Avast Marine
RC Sponsor
 
Avast Marine's Avatar
 
Join Date: Feb 2006
Location: Northern VA
Posts: 2,446
Hi Steve,

For resin medias this is how you want it setup:

Bottom stainless screen, no ball, top plate should be opened up and you put the foam disk below the stainless disk and reassemble. You want the flow to to be very gentile so it just moves barely moves the media.

The bottom screen prevents media backflow and removing the ball makes the flow less "touchy" with the resin media. The foam under the ss mesh in the top prevents the screen from clogging there.

I have personally never used po4x4 but this works very well with the other resin medias I have personally tested.


__________________
Dan

Don't rush art, you get bad art.
Avast Marine is offline   Reply With Quote