Thread: My 5x2x2 build
View Single Post
Old 03/25/2018, 03:46 AM   #8
SpicyBurrito
Registered Member
 
Join Date: Jan 2018
Posts: 5
I am looking to visit the cabinet makers during the next week. I am a little unsure if I should cut a hole in the top to let out any excess heat from inside the hood or not. I was going to have a circle cut directly above where I was going to mount the lights but I forgot that the Radion lights fans are actually on the underside of the light so this would not really work.

Looking for opinions on wether you would go with a hole cut the size of each of the lights above them, or a single hole in the middle of the hood basically between the two lights.




SpicyBurrito is offline   Reply With Quote