Thread: My 5x2x2 build
View Single Post
Old 03/25/2018, 04:33 PM   #9
Dsekula
Registered Member
 
Dsekula's Avatar
 
Join Date: Jan 2018
Location: Sterling
Posts: 271
Quote:
Originally Posted by SpicyBurrito View Post
I am looking to visit the cabinet makers during the next week. I am a little unsure if I should cut a hole in the top to let out any excess heat from inside the hood or not. I was going to have a circle cut directly above where I was going to mount the lights but I forgot that the Radion lights fans are actually on the underside of the light so this would not really work.

Looking for opinions on wether you would go with a hole cut the size of each of the lights above them, or a single hole in the middle of the hood basically between the two lights.

I'd personally go with one over each light for more direct transfer, size them the size of normal pc fans and you could add fans later if there are heat issues. If there aren't issues you just happen to have the right size hole . Just a thought.

Sent from my E6810 using Tapatalk


Dsekula is offline   Reply With Quote