View Single Post
Old 01/25/2014, 11:47 AM   #63
Haksar
Registered Member
 
Haksar's Avatar
 
Join Date: Sep 2007
Location: Dubai
Posts: 1,041
Quote:
Nothing will change. Right now your regulator turns the gas on and off based on the controller. You don't want to change the total amount of gas input you just want to make it so it delivers it in a steady stream. The reason you set the controller to turn the reg off if it gets to low is so that you don't mess something up. One of the easiest ways to adjust this is to operate the setup like normal and just back off the gas until it never turns off. After you get there you can change your ph lower and the regulator should just run and run at the correct delivery rate.
Sorry I am a bit confused does this mean I need to lower the ph in the controller for the regulator to run continuously without dropping the BPM.


__________________
Haksar
Haksar is offline   Reply With Quote